Heavy Hitter Talaria Billet Race Suspension Linkage

A 7075 billet aluminum rear suspension linkage with steel bushings, pre-assembled with new bearings, bushings, and seals. Designed to replace the known weak point in the stock Talaria suspension setup that causes noise, play, and eventual bearing and linkage failure. Engineered with a 4mm top-out stop to protect rear shock seals from slamming at full droop a critical feature no e-moto rear shock includes from the factory.

Fitment:

• Talaria Sting MX3 / MX4 / MX5

NOTE: Only fits 10.5 x 3.5-inch and smaller shocks. Longer shocks are not advised. Always grease bearings before installing.

The 4mm preload design lightly rests the linkage on the swingarm at full droop with the rear wheel off the ground, acting like a limiting strap to prevent premature shock seal and rebound control damage. Especially important for heavier riders running 550-650 lb springs and riders who send big jumps. Type 2 black anodized finish. Simple installation in 20 minutes or less. Stop the play, stop the noise, and protect your shock for the long run.